Home Categories Send inquiry

Agricultural machinery classification of plow type


The working characteristic of rotary cultivator is high speed rotation of working parts, almost all safety problems are related to this. To this end, the following points should be paid attention to when using rotary cultivator:

news4

1, before use should check the components, especially check whether the rotary tillage knife is installed and fixed bolts and universal joint lock pin is firm, found that the problem should be dealt with in time, confirm safe before use.

2. Before starting the tractor, the clutch handle of the rotary cultivator should be moved to the separation position.

3, to lift the state of engagement power, until the rotary cultivator to reach the predetermined speed, the unit can start, and the rotary cultivator slowly lowered, so that the rotary knife into the soil. It is strictly forbidden to start the rotary blade directly when it is put into the ground to prevent the damage of the rotary blade and related parts. It is forbidden to descend the rotary cultivator rapidly, and it is forbidden to backtrack and turn after the rotary cultivator is put into the soil.

4. When the ground turns and the power is not cut off, the rotary cultivator shall not be raised too high, the transmission Angle at both ends of the universal joint shall not exceed 30 degrees, and the engine speed shall be appropriately reduced. When transferring the land or walking for a long distance, the power of the rotary cultivator should be cut off and locked after rising to the highest position.

5. When the rotary cultivator is running, people are strictly prohibited from approaching the rotating parts, and no one is allowed behind the rotary cultivator, in case the blade is thrown out and hurts people.

6. When checking the rotary cultivator, the power must be cut off first. When replacing rotating parts such as blades, the tractor must be turned off.

7, tillage forward speed, dry field to 2 ~ 3 km/h is appropriate, in has tilled or raked the ground to 5 ~ 7 km/h is appropriate, in paddy field tillage can be appropriately fast. Remember, the speed can not be too high, in order to prevent the tractor overload and damage to the power output shaft.

8. When the rotary cultivator works, the tractor wheels should walk on the uncultivated land to avoid compacting the cultivated land, so it is necessary to adjust the wheel base of the tractor so that the wheels are located in the rotary cultivator working range. When working, we should pay attention to the method of walking to prevent another wheel of the tractor from compacting the cultivated land.

9. In the operation, if the cutter shaft is too much wrapped grass, it should be stopped and cleaned in time to avoid increasing the load of the machine and tools.

10, rotary tillage, the tractor and suspension part is not allowed to ride, in order to prevent accidental injury by rotary cultivator.

11. When using the rotary tiller group of walking tractors, only when the deputy gear lever is placed in the “slow” position can the rotary tiller file be hung. If you need to reverse in work, you must put the gear lever in neutral to hang the reverse gear. In rotary tillage, steering clutch is not used as far as possible, and push and pull handrails are used to correct the direction. When turning on the ground, the accelerator should be reduced first, the handrail should be held up, and then the steering clutch should be pinched. Do not turn a dead turn to prevent damage to the parts.